What is the Optimum Height for Drinking a Milkshake with a Vertical Straw?

AI Thread Summary
The discussion centers on the physics of drinking a milkshake through a vertical straw, specifically examining the height at which the straw must be positioned for effective drinking. It is established that the pressure head generated by human lungs (3000 Pa) is insufficient to overcome the height of the milkshake in the straw, preventing drinking. For optimal height, the straw must be positioned just below the pressure head limit to allow the milkshake to flow. Bernoulli's equation is referenced as a potential method for calculations, but a simpler pressure difference approach is deemed sufficient. Ultimately, the participant successfully resolves the problem after clarification on the concepts involved.
Adriano Roma
Messages
2
Reaction score
0
Member advised to use the formatting template for questions posted to the homework forums
You and a friend of yours went for a drink of chocolate milkshake(ρ=1200 kg/m3). The waiter brings your drink in two glasses 200 mm tall with a straw 8 mm in diameter and 300 mm long. Given that human lungs capacity can develop approximately 3000 Pa of vacuum pressure and assuming that the straw is barely inserted into the milkshake:
(a) Verify that you won't be able to drink the milkshake through the vertical straw.
(b) Determine the optimum height of the vertical straw above the milkshake that allows the drink to just flow to your mouth.

As far as I understood, for point (a) I think I need to verify that the pressure head corresponding to the pressure difference between the bottom and the top of the straw is shorter than the straw and for point (b) I would say that the hight of the straw above the drink has to be slightly less than the pressure head corresponding to the pressure difference.

I think I need to apply Bernoulli's equation but don't know how to proceed!

Could you please give me some hints? I attached an image which illustrates the problem.

Thank you in advance.
 

Attachments

  • Prob.jpg
    Prob.jpg
    10 KB · Views: 520
Physics news on Phys.org
Hello Adriano, benvenuto :welcome:

Bernoulli's equation is an energy balance. In this case a pressure difference calculation is sufficient. For a, and for b too !

PS nice illustration !
 
  • Like
Likes Adriano Roma
Thank you very much, I managed to solve it. I just didn't understand Bernoulli's equation!
Regards
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Trying to understand the logic behind adding vectors with an angle between them'
My initial calculation was to subtract V1 from V2 to show that from the perspective of the second aircraft the first one is -300km/h. So i checked with ChatGPT and it said I cant just subtract them because I have an angle between them. So I dont understand the reasoning of it. Like why should a velocity be dependent on an angle? I was thinking about how it would look like if the planes where parallel to each other, and then how it look like if one is turning away and I dont see it. Since...
Back
Top