Why does a channel bend and twist when force is applied through the centroid?

3 replies · 2K views · last reply
fonseh
Messages
521
Reaction score
2

Homework Statement


In the notes , the author stated that when the force is applied through the centorid of cross section , the channel will bend and twist.
but , on the second page , the author stated that the shear center lies on an axis of symmetry of member's cross sectional area...
So, i am confused whether the member will twist or not when the force P is applied thru the centroid or shear center ...

Why the shear center is located at O , which is located outside of the C channel ?

Homework Equations

The Attempt at a Solution


Is there anything wrong with the notes ? [/B]
 
Attachments
  • Textbook figure Fig. 7-23 showing a channel-section cantilever beam under an end load P applied through the centroid; panels a and e show the bent and twisted beam, b shows shear-flow distribution, c and d show the shear force and shear center O outside the channel.
    438.PNG
    56.6 KB · Views: 533
  • Textbook page on shear center of open thin-walled members, with a photo of a cantilever beam deflecting through the centroid and a diagram of a channel section with force P and shear flows, labelled Fig. 7-24.
    439.PNG
    89.4 KB · Views: 517
In the notes , it's also stated that to prevent twisting , the P should be applied at O , does it mean we have to apply the force thru the centoid and also at the O at the same time to prevent twisting ? I'm confused
 
what is the meaning of the force is applied along the once vertical , unsymmetrical axis that passes thru centroid ? Since the applied force already passing thru centroid , it's already the symmertical axis , right ?