Why does point A use cos30 instead of cos45?

1 reply · 2K views · last reply
Pipsqueakalchemist
Messages
141
Reaction score
20
Homework Statement
Questions and attempt below
Relevant Equations
Work energy theorem
So for this question I got the right angular velocity. But I don’t get the same velocity for point A. I don’t understand why it’s cos30, problem asked for V_a when theta = 45 so I used cos45. I have my work below.
 
Attachments
  • Textbook problem 17.37 beside a diagram of a 5 m ladder leaning against a brick wall, with end A on the ground and end B on the wall, at angle theta from the ground.
    A72919C6-0166-484D-A38C-3490C7312733.png
    30.1 KB · Views: 231
  • Printed solution page on kinematics and energy of a sliding ladder, with a diagram of ladder AB with center G and velocities at A and B, plus a second ladder diagram with mg, h and angle theta.
    7B9218CC-DEC6-4477-A0DF-F04C8836511B.png
    25.5 KB · Views: 229
  • Printed solution page for Problem 17.37 (Continued) showing rod positions at 20 and 45 degrees, energy equation, angular velocity 1.170 rad/s, and velocity of end A v_A = wL cos30 = 5.07 m/s.
    C63D4BB0-F2C3-4159-91B3-134371A3412A.jpeg
    26.5 KB · Views: 209
  • Handwritten solution on lined paper to problem 17.37: energy equation with cos 20 and cos 45 terms, two triangle sketches labelled with lengths 3.54, 2.5, 5 and angle 45, law of cosines giving d = 2.503, then w = 1.17 rad/s and V_A = 4.14 m/s.
    image.jpg
    53.1 KB · Views: 242
Your images of your work are pretty much illegible. Can you please type your work into the forum using LaTeX? See the LaTeX Guide link at the lower left. Thank you.