Will blocking oil flow increase pressure in a hydro-pneumatic intensifier?

  • Thread starter Thread starter Yogesh Kulkarni
  • Start date Start date
  • Tags Tags
    Flow Oil
Join the discussion
Registration is free. Ask a follow-up in this thread, or start your own.
Sign up Log in
3 replies · 2K views
Yogesh Kulkarni
Messages
2
Reaction score
0
Hello,
I am trying to design a hydro penumatic circuit. I have shop air at 80 Psi. I need hydraulic pressure of 160 PSI. So I am using pressure booster/Intensifier to pressurise it. there will be air on one side of intensifier and oil on other side of it. my question is if I block path of oil will there be increase in pressure?
 

Discussion

Physics news on Phys.org
Welcome to PF.

It will depend on what type of intensifier are you using.
Please give us a link to the device.

If all you want is pressure with very low flow you might be able to use a hydraulic cylinder with oil on the rod side and air on the piston face. Many cylinders have a rod area that is close to half the piston face area.
 
Baluncore said:
Welcome to PF.

It will depend on what type of intensifier are you using.
Please give us a link to the device.

If all you want is pressure with very low flow you might be able to use a hydraulic cylinder with oil on the rod side and air on the piston face. Many cylinders have a rod area that is close to half the piston face area.
Thanks for your reply.
I am using milwaukee pressure booster
http://www.milwaukeecylinder.com/
 
Yogesh Kulkarni said:
my question is if I block path of oil will there be increase in pressure?
Yes. The pressure ratio of a booster is fixed by the ratio of cylinder area to rod area. The maximum output pressure will be the input pressure * compression ratio.
The volume of pressure boosted oil available per cycle is limited to the booster cylinder oil capacity.
If you do not block the oil path, the booster will push oil through the system until the booster reaches the end of it's travel, without reaching the full boosted pressure.