Recent content by sdoi
-
S
Conservation of energy with a mass and pulley system.
As in, Etotal= Eg, Etotal'=Ek ?- sdoi
- Post #3
- Forum: Introductory Physics Homework Help
-
S
Conservation of energy with a mass and pulley system.
Homework Statement Two boxes are attached to opposite ends of a rope passing over a frictionless pulley as shown below. The mass of Box A is 15kg and the mass of box B is 12kg. The system is originally at rest with the bottom of box A at a height of o.85m above the floor. When the system is...- sdoi
- Thread
- Conservation Conservation of energy Energy Mass Pulley Pulley system System
- Replies: 3
- Forum: Introductory Physics Homework Help
-
S
Solving tension equations with trig.
Homework Statement There are four pieces of rope tied between four trees. Given the forces of tension in three of the strands, find the force of tension in the remaining rope. Rope 1: 2.1x10^-3N [20°E of N] Rope 2: 1.6x10^-3N [60° E of S] Rope 3: 1.9x10^-3N [40° W of S] Homework...- sdoi
- Thread
- Tension Trig
- Replies: 1
- Forum: Introductory Physics Homework Help
-
S
True mass, different weights, and the force of gravity
Homework Statement An astronaut enters a rocket ship and gets blasted to another planet. The mass of the planet is 2.5 times as large as the mass of Earth, and the radius is 1.2 times as large as Earth's. If the astronauts scale at home says "60.0kg", what will it say on the new planet? In...- sdoi
- Thread
- Force Force of gravity Gravity Mass
- Replies: 1
- Forum: Introductory Physics Homework Help
-
S
Tension and friction on an angle
Ok, I'm just a little confused as to what you were trying to say before. μmg, where does that equation come from? (0.11)(47kg)(9.8m/s^2) =50.6N and what does that give me? is that the horizontal component of Ft?- sdoi
- Post #5
- Forum: Introductory Physics Homework Help
-
S
Tension and friction on an angle
μmg= Fs does it not? By finding the Fs I can determine the minimum horizontal force needed for the sled to move, but μ is for kinetic friction, I didn't think I could use that for static friction.- sdoi
- Post #3
- Forum: Introductory Physics Homework Help
-
S
Tension and friction on an angle
Homework Statement An adult is pulling two small children in a sleigh over level snow. The sleigh and children have a total mass of 47kg. The sleigh rope makes an angle of 23degrees with the horizontal. The coefficient of kinetic friction between the sleigh and the snow is 0.11. Calculate the...- sdoi
- Thread
- Angle Friction Tension
- Replies: 5
- Forum: Introductory Physics Homework Help
-
S
Kinetic frictions, pulleys, and Newton's third law
Homework Statement Block A and B are connected by a string passing over an essentially frictionless pulley. (Block A is on a horizontal plane, while block B is suspended in the air) When the blocks are moving block A experiences a force of kinetic friction of magnitude 5.7N. If mA= 2.7kg and...- sdoi
- Thread
- Kinetic Law Newton's third law Pulleys Third law
- Replies: 1
- Forum: Introductory Physics Homework Help
-
S
Forces and state of equilibrium
In order for the plane no remain airborne there needs to be a normal force as well to cancel out the force of gravity and air resistance to counter the forward thrust of the engine.- sdoi
- Post #7
- Forum: Introductory Physics Homework Help
-
S
Forces and state of equilibrium
Two forces, Negative force of gravity, and the thrust of the engine.- sdoi
- Post #5
- Forum: Introductory Physics Homework Help
-
S
Forces and state of equilibrium
oh sorry, "If the forward thrust provided by the engine is..."- sdoi
- Post #3
- Forum: Introductory Physics Homework Help
-
S
Forces and state of equilibrium
Homework Statement Assuming an aircraft has a force of gravity of 6.6x10^4N [down] acting on it as it travels at a constant velocity of 6.4x10^2 km/h [w]. If the engine is 1.3x10^4N [W] determine: (a) The upward lift force on the plane (b) The force due to air resistance on the plane...- sdoi
- Thread
- Equilibrium Forces State
- Replies: 7
- Forum: Introductory Physics Homework Help
-
S
Forces and Vectors adding to zero
And that simple mistake complicated everything. That pretty much fixes all of the problems I was having. Thank you very much!- sdoi
- Post #8
- Forum: Introductory Physics Homework Help
-
S
Forces and Vectors adding to zero
I'm working on it, I can't seem to find it in my PF.- sdoi
- Post #5
- Forum: Introductory Physics Homework Help
-
S
Forces and Vectors adding to zero
Within my calculations I have used the appropriate angles, right? I've kept each axes in mind. Did I calculate the resultant correctly? I'm not entirely sure how to find the angle. I do however know from my diagram that it will be some degree N of W. Without the appropriate angle I cannot...- sdoi
- Post #3
- Forum: Introductory Physics Homework Help