The problem involves calculating the current through a 5-ohm resistor with a 20V potential difference. The correct calculation is 20V divided by 5 ohms, which equals 4 A, as the unit for current is amperes (A). The initial response incorrectly stated the result as volts instead of amperes. It's important to clearly show the equation before substituting values to avoid confusion. Accurate unit representation is crucial in circuit calculations.
#1
wakejosh
101
0
Homework Statement
you measure a 20v potential difference across a 5 ohm resistor. what is the current?
No, not correct; your units are wrong
(why would a volt divided by an ohm be a volt?)
And, if you're looking for current, what is the SI unit for current?
Otherwise, it's fine. Personally, I prefer to see the equation you used before you plug in values.
The book claims the answer is that all the magnitudes are the same because "the gravitational force on the penguin is the same". I'm having trouble understanding this. I thought the buoyant force was equal to the weight of the fluid displaced. Weight depends on mass which depends on density. Therefore, due to the differing densities the buoyant force will be different in each case? Is this incorrect?