Circuit with two voltage sources (Kirchoff Rules)

3 replies · 11K views · last reply
XianForce
Messages
16
Reaction score
0

Homework Statement


The circuit shown in the figure below is connected for 3.10 min. (Assume R1 = 7.90 Ω, R2 = 2.60 Ω, and V = 16.0 V.)
Circuit schematic with resistors R1, 5.00 Ω, 1.00 Ω, 3.00 Ω and R2, and voltage sources 4.00 V and V, with polarity marks on each source.

The circuit shown in the figure below is connected for 3.10 min. (Assume R1 = 7.90 Ω, R2 = 2.60 Ω, and V = 16.0 V.)


Homework Equations


Kirchoff's Rules
V = IR


The Attempt at a Solution


So naming the current in the left segment I1 downwards, the current in the middle section I2 downwards, and the current in the right most section I3 upwards, I find from the junction rule that I1 + I2 = I3. Then using the current rule, I find that -16 +7.9 * I1 + 2.6 * I3 = 0. Substituting in I3 as I1 + I2, and then solving for I1 I find that I1 = (16 - 2.6I2) / 10.5 . Using the current rule again, I find that -4 + 7.9 * I1 - 6.0 * I2 = 0 and so I substitute for I1 and then solve for I2 to find that I2 = 1.0103. Then use that value back in other equations to find that I1 = 1.2736 Amperes downward, I2 = 1.0103 Amperes downward, and I3 = 2.2839 Amperes Upward.

Web Assign keeps saying these values are wrong and I have reworked these problems several times and keep getting the same answers.
 
XianForce said:

Homework Statement


The circuit shown in the figure below is connected for 3.10 min. (Assume R1 = 7.90 Ω, R2 = 2.60 Ω, and V = 16.0 V.)
Circuit schematic with resistors R1, 5.00 Ω, 1.00 Ω, 3.00 Ω and R2 and two batteries, 4.00 V and V, arranged in a loop.

The circuit shown in the figure below is connected for 3.10 min. (Assume R1 = 7.90 Ω, R2 = 2.60 Ω, and V = 16.0 V.)

Homework Equations


Kirchoff's Rules
V = IR

The Attempt at a Solution


So naming the current in the left segment I1 downwards, the current in the middle section I2 downwards, and the current in the right most section I3 upwards, I find from the junction rule that I1 + I2 = I3. Then using the current rule, I find that -16 +7.9 * I1 + 2.6 * I3 = 0.

R2 is connected to a 3 ohm resistor in series.

ehild
 
XianForce said:
I cannot believe I missed that. Thank you!

You are welcome.:smile:

ehild