Crossing Point Distance Calculation

  • Thread starter Thread starter zn23
  • Start date Start date
  • Tags Tags
    Kinematics
AI Thread Summary
To find the crossing point of two stones thrown from a cliff, one upward and the other downward, both at 7 m/s, the height of the cliff is 4 m. The key equations to use are y up = v1t + 1/2at^2 for the upward stone and y down = v1t + 1/2at^2 for the downward stone. The stones will cross when they have traveled for the same time and have equal displacements from the ground. It is suggested to set the displacements equal to each other, leading to the equation s = y up = (4 - y down). The discussion emphasizes the importance of using the correct equations and understanding the relationship between time and displacement in this scenario.
zn23
Messages
18
Reaction score
0

Homework Statement


Two stones are thrown simultaneously, one straight upward from the base of a cliff and the other straight downward from the top of the cliff. The stones are thrown with the same speed.
The height of the cliff is 4 m and the speed with which the stones are thrown is 7 m/s.

find the distance of the crossing point above the ground.

Homework Equations



gotta use these using the equations y up = v1t + 1/2at^2, and y down = v1t + 1/2at^2

The Attempt at a Solution


well so far i went v= x / t and found t = x / v, which was 0.6 s i plugged it in both equations, but i don't know what to do next add the displacements or what ?
 
Last edited:
Physics news on Phys.org
zn23 said:

Homework Statement


Two stones are thrown simultaneously, one straight upward from the base of a cliff and the other straight downward from the top of the cliff. The stones are thrown with the same speed.
The height of the cliff is 4 m and the speed with which the stones are thrown is 7 m/s.

find the distance of the crossing point above the ground.


Homework Equations



gotta use these using the equations y up = v1t + 1/2at^2, and y down = v1t + 1/2at^2


The Attempt at a Solution


well so far i went v= x / t and found t = x / v, which was 0.6 s i plugged it in both equations, but i don't know what to do next add the displacements or what ?


The equation v = x/t is for constant velocities only, ie a = 0. So using it in this question is not going to help. You are looking for the point where the stones cross - at this point they will have the same displacement from the ground and will have traveled for the same length of time.

Use this information in your two relevant equations to find s = y up = (4 - y down) where s is the displacement from the ground at time t.
 
what wud u suggest another way to find time wud be ?
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top