Finding potential between points A and B with Kirchhoff's law

8 replies · 2K views · last reply
Questions999
Messages
151
Reaction score
0
I am solving a VERY complicated exercise and I have this part that I don't understand.The image posted is a very big simplification of a part of the exercise.I have to find the potential between A and B.My question : Are the 15 Volt and the 13 Volt in the picture involved in the calculation?
I know I have to calculate the potential using Kirch.law btw.
 
Attachments
  • Circuit diagram: a horizontal wire with branches to A and B, each branch with a circle marked 12 V at A, 13 V below the wire, 14 V at B, and 15 V below the right side.
    gfddf.JPG
    5.6 KB · Views: 470
Elaia06 said:
I am solving a VERY complicated exercise and I have this part that I don't understand.The image posted is a very big simplification of a part of the exercise.I have to find the potential between A and B.My question : Are the 15 Volt and the 13 Volt in the picture involved in the calculation?
I know I have to calculate the potential using Kirch.law btw.

Do the lines represent wires only? If so, the 13V and 15V sources have no effect on the KVL sum from A to B.
 
The lines represent wires and they have resistances in it.
 
Elaia06 said:
Are the 15 Volt and the 13 Volt in the picture involved in the calculation?

Not if one end is open circuit. Are they really open circuit?
 
Elaia06 said:
The lines represent wires and they have resistances in it.

That's a confusing statement. Are the lines wires, with the resistances represented by the circled potential changes? Or are there hidden potential changes in the lines along the path from A to B?
 
Sorry.13 V is also resistance,15 V is only wire.
 
Elaia06 said:
Sorry.13 V is also resistance,15 V is only wire.

How can a wire be 15 V? Do you mean it is a wire that is at a 15 V potential, or leads to a 15 V source? Something like this:

Circuit diagram of a blue wire node with labelled resistors: A at upper left with 12 V, B at upper right with 14 V, a lower branch with 13 V, and 15 V at the lower right; arrows marked Same Node; a branch labelled To some other node.
 
Attachments
  • Circuit diagram of a blue wire node with black resistor symbols at A and B, red labels 12 V, 14 V, 13 V and 15 V, arrows marked Same Node, and a branch labelled To some other node.
    Fig1.gif
    2.4 KB · Views: 573
Wire that has a 15 V potential.The image is very right!
 
Elaia06 said:
Wire that has a 15 V potential.The image is very right!

Okay. Then consider that a single node can only be at a single potential; there is no potential difference between any points connected by a contiguous wire. In this case, the blue wires in the figure represent one node. The only potential changes that occur along the path from A to B are those due to the 12 V and 14 V drops.