How Does the n Factor Arise in the QFT Generating Functional Equation?

1 reply · 2K views · last reply
binbagsss
Messages
1,291
Reaction score
12

Homework Statement



Hi

I am looking at the attached question part c)

Typeset page of a physics problem on zero-dimensional field theory with action S(phi) and generating functional Z(J), parts (a) to (c), ending with the Schwinger-Dyson relation for correlation functions in phi^4 theory.


Homework Equations



below

The Attempt at a Solution



so if i take ##\frac{\partial^{(n-1)}}{\partial_{(n-1)}} ## of (2) it is clear I can get the ##\frac{i}{h} (\lambda_2 +\lambda_4 )## like-term, but I am unsure about the ##nG_{n-1}## .

There's obviously no other derivatives on the RHS so I will only yield a ##G_{n-1}## and that looks fine, I am a bit confused though, I can yield this from the ## Z[J] ## alone on the RHS, whereas the RHS is ##Z[J]## 'multiplied by' (it is already inside the integral) the extra term of ##S'[\Phi] + J## . So I suspect this extra term is the reason we get the ##n## factor but I am unsure how.

Looking at the LHS there is a single ##J## so it looks like this gives a factor of ##1## and then we take across ##(n-1)## from the RHS.

If I take a derivative wrt ##J##, on the LHS I can either act on the exponential or the single ##J## (but can only act on this ##J## once,) on the RHS it's the same story, with the difference that on the LHS the ##J## is outside the integral but on the RHS it is inside the integral, I'm trying to use this to deduce where the factor of ##n## comes from but I am struggling..
 
Attachments
  • Typeset page of a physics problem on zero-dimensional field theory with action S(phi) and generating functional Z(J), parts (a) to (c), ending with the Schwinger-Dyson relation for correlation functions in phi^4 theory.
    generatingfunctional2.jpg
    38 KB · Views: 941