How Is Deflection Calculated for a Partially Supported Circular Lid?

3 replies · 2K views · last reply
Rajashekar
Messages
7
Reaction score
0
Hi
In one of my application I am using a linear actuator to lift a 30kg lid which has a diameter of 380mm.
I can only use 1/3rd portion on the lid to take support, for actuator which I used a 60*20*180 long plate mounted to the lid and lift.

How to calculate the deflection of lid when lifted to 100mm
 
Rajashekar said:
Hi
In one of my application I am using a linear actuator to lift a 30kg lid which has a diameter of 380mm.
I can only use 1/3rd portion on the lid to take support, for actuator which I used a 60*20*180 long plate mounted to the lid and lift.

How to calculate the deflection of lid when lifted to 100mm
Welcome to the PF.

Can you post a diagram of your setup? It's a bit hard to understand your question (at least it is for me). Thanks. :smile:
 
  • Like
Likes   Reactions: Rajashekar and mechpeac
berkeman said:
Welcome to the PF.

Can you post a diagram of your setup? It's a bit hard to understand your question (at least it is for me). Thanks. :smile:
Hello Berkeman,
Thanks for your reply. Here is the image
I have attached, the plate is mounted to lid using 4- M10 screws and the lid is lifted to 100mm length

Thanks in advance:smile:
 
Attachments
  • Hand-drawn side-view sketch of a mechanism: a rectangular plate labelled 65 wide x 200 long x 20 thk sits on a circular lid of diameter 380 mm, with a linear actuator of 100 mm stroke below it and an upward arrow.
    P_20160305_085239_1.jpg
    34.3 KB · Views: 458
Rajashekar said:
Hello Berkeman,
Thanks for your reply. Here is the image
I have attached, the plate is mounted to lid using 4- M10 screws and the lid is lifted to 100mm length

Thanks in advance:smile:
The lid weight is 30kg, the actuator load carrying capacity 1500N.