Introductory physics: Time for a ball thrown vertically to reach maximum height

Click For Summary
The discussion revolves around a physics problem regarding the time it takes for a ball thrown vertically to reach maximum height. A participant calculates the maximum height using the freefall equation and arrives at a distance of 11.4 meters. However, the main focus of the problem is to determine the time in seconds, not the height in meters. There is confusion regarding the interchange of variables "x" and "d," as well as the clarity of the images shared in the forum. The conversation emphasizes the need to address the time calculation rather than the height achieved.
danielsmith123123
Messages
26
Reaction score
4
Homework Statement
A 3 kg ball is thrown vertically into the air with an initial velocity of 15 m/s. What is the time it takes for the ball to reach its maximum height?
Relevant Equations
Vf =vi +at
Vf^2 = Vi^2 +2ax
x = Vf t - (1/2)(a)(t^2)
x = Vi t + (1/2)(a)(t^2)
Is the answer key wrong? I keep getting the same answer and it is verified with the freefall equation distance=1/2 (g)(t^2)
IMG_5721[1120].PNG
 
Last edited by a moderator:
Physics news on Phys.org
You should write the full text of the problem, not an abstract of it. Where did the value of d comes from?
 
Ok thank you, i edited the forum. I guess you can't open pictures on this website, but i calculated d with Vf^2=Vi^2 +(2)(a)(d)
0^2 = 15^2 + (2)(-9.8)d
d = 11.4m
(I realize i probably shouldn't use "x" and "d" interchangibly)
 
You found the maximum height. The problem is asking you to find the time it takes to reach that maximum height. Your answer should be a number in seconds, not meters.
 
danielsmith123123 said:
Ok thank you, i edited the forum. I guess you can't open pictures on this website, but i calculated d with Vf^2=Vi^2 +(2)(a)(d)
0^2 = 15^2 + (2)(-9.8)d
d = 11.4m
(I realize i probably shouldn't use "x" and "d" interchangibly)
You don't need the height but you got it OK. What is your problem? I cannot read the image you posted. It is not clear enough.
 
If have close pipe system with water inside pressurized at P1= 200 000Pa absolute, density 1000kg/m3, wider pipe diameter=2cm, contraction pipe diameter=1.49cm, that is contraction area ratio A1/A2=1.8 a) If water is stationary(pump OFF) and if I drill a hole anywhere at pipe, water will leak out, because pressure(200kPa) inside is higher than atmospheric pressure (101 325Pa). b)If I turn on pump and water start flowing with with v1=10m/s in A1 wider section, from Bernoulli equation I...

Similar threads

Replies
5
Views
1K
  • · Replies 38 ·
2
Replies
38
Views
4K
  • · Replies 25 ·
Replies
25
Views
1K
  • · Replies 40 ·
2
Replies
40
Views
3K
  • · Replies 15 ·
Replies
15
Views
2K
  • · Replies 8 ·
Replies
8
Views
3K
  • · Replies 9 ·
Replies
9
Views
2K
  • · Replies 8 ·
Replies
8
Views
3K
Replies
3
Views
2K
  • · Replies 4 ·
Replies
4
Views
2K