RC circuit charging with switch opening at 2V capacitor voltage

7 replies · 3K views · last reply
erezb84
Messages
43
Reaction score
0

Homework Statement


S1 switch - always close.
S2 switch is closed, until the capacitor voltage reaches 2V.
given: R,C,V values.
V0 = 0V.
Need to find Vout while S1+S2 are closed and until S2 opens.

Homework Equations


Vc(t) = (Vi - Vf)*(exp -t/TAU) + Vf

The Attempt at a Solution


I have found the Vc(t) equation (until S2 opens) and got:
Vc(t) = 2/3V1*(1-exp(-3t/5RC))
but now i am alittle bit confused.
can't i tell that by KVL for the large loop (through S2) each R has V1/3 voltage?
or i can't do it because we are in the charging stage?
thanks.
 
Attachments
  • Circuit schematic: a voltage source V1 feeds a ladder of resistors labeled R, with a branch containing R in series with capacitor C and switch S1, and a second branch with R in series with switch S2, and output marked Vout.
    Capture.JPG
    8.4 KB · Views: 619
V0 is the capacitor initial voltage.
V1 is the source voltage
 
Vout = V1(1/2.5 - 1/3)exp(-t/T) + V1/3

T = {R + R||2R}C.

Initially you have C charged to V1 so the Thevenin equivalent is V1 connected to the rest of the circuit by R/2. So Vout(0+) = V1R/(2.5R). At t = ∞ you have C out of the picture so Vout(∞) = V1/3.

You know the output must take the form Vout = a*exp(-t/T) + b. So you fit a and b:
Vout()+) = a + b, V(∞) = b.

Then T is by inspection R + R||2R since that is the total impedance C sees going to hard voltages (impedance = 0).
 
erezb84 said:
V0 is the capacitor initial voltage.
V1 is the source voltage

If V0 is initial capacitor voltage, it is not zero. It is V1.

I assume V1 is constant, -∞ < t < +∞
S1 closed.
S2 open, t < 0 and closed, t > 0.

If this is incorrect you need to define the problem better.

See you in about 8 hrs.
 
erezb84 said:
can't i tell that by KVL for the large loop (through S2) each R has V1/3 voltage?
Series resistors [any number of] can be considered to form a simple proportional voltage divider ONLY if all carry the same current. Clearly, that is true in your case ONLY if zero current is going into the capacitor branch. This condition (of zero capacitor current) becomes true only once the capacitor has reached full charge. So that potential divider sets the voltage the capacitor eventually could attain, but until then, one of the resistors carries more current than do the other two.
 
Last edited: