Remove sugar from industrial wastewater

  • Thread starter Thread starter mathsTKK
  • Start date Start date
  • Tags Tags
    Industrial Sugar
AI Thread Summary
A new forum member seeks advice on addressing high sugar content and BOD levels in wastewater from a sweets production factory, which fails to meet environmental standards. The water report indicates high sugar and BOD levels, with BOD at over 5000 mg/L compared to a standard of 80 mg/L. The flow rate of the wastewater is between 900-1000 L/hr. The member has researched potential solutions, including Biomembrane Reactors and Reverse Osmosis (RO), but is concerned about the cost of RO systems. Suggestions from other forum members include exploring specialized companies that focus on sugar removal from wastewater, emphasizing that the relatively small flow rate may allow for a more affordable solution.
mathsTKK
Messages
31
Reaction score
0
Good evening everyone! I am new to this forum, nice to know any member in this forum ^^

I have a question here which I can't figure out how to solve a problem. Recently, I have been asked about the water filtration system in a factory which produce sweets. The sugar can't be removed from the wastewater, causing it to fail to meet the environment standard of wastewater. The water report shows that the sugar content and BOD is high but others are fine.


I have done some research from the internet and found one common term which is the Biomembrane Reactor. Some claim that RO may also be one of the solutions. However, I think that RO System will be very expensive. Therefore, can someone suggest what system should be used to remove the sugar in wastewater with explanations of the process?


Your kind assistance is highly appreciated. I hope that some can help me to solve this problem. I'm sure that this discussion will be mutually beneficial ^^


Thank you everyone!





From,
mathsTKK
 
Engineering news on Phys.org
Can someone please help me? tq :)
 
What is the concentration and flow rate?
 
According to the water report, the BOD and COD are particularly high. COD 19.8 compared to standard of 20 whereas BOD 5000++ compared to standard of just 80 mg/L. Besides, the concentration of iron is 1.3 compared to 1.0 as the standard limit.

The flow rate is 900-1000 L/Hr.

The factory produces sugar product and high content of sugar has been detected. Is there an easier way to solve the problem?
Thank you so much for your concern ! I truly appreciate !
 
Last edited by a moderator:
Back
Top