Resistance between points A and B with three resistors

  • Thread starter n77ler
  • Start date
  • Tags Tags
    Resistance
5 replies · 3K views · last reply
n77ler
Messages
89
Reaction score
0
[SOLVED] Finding Resistance

Homework Statement


A number of resistors of values R1 = 3.8 Ω, R2 = 80.0 Ω, and R3 = 20.0 Ω are connected as shown in the figure. What is the resistance between points A and B?


Homework Equations





The Attempt at a Solution



Im confused because all I've been calculating is the equivalent resistance, what is the difference between the two?
 
Attachments
  • Circuit schematic of a resistor network between terminals A and B: two rows of resistors labelled R1 joined by a middle rung R2 and an outer rung R3 on the right.
    A5Problem25.gif
    2.3 KB · Views: 492
n77ler said:

Homework Statement


A number of resistors of values R1 = 3.8 Ω, R2 = 80.0 Ω, and R3 = 20.0 Ω are connected as shown in the figure. What is the resistance between points A and B?


Homework Equations





The Attempt at a Solution



Im confused because all I've been calculating is the equivalent resistance, what is the difference between the two?


They are just asking for the equivalent resistance of that network, as seen at the entry points A & B. Just use your series & parallel combination rules to reduce the network to a single (equivalent) resistor between A & B, and you will have your answer.
 
The Four R1 and R3 are in series thus those five resistors to the right can be combined by adding the value...(4*3.8+20)=35.2Ω
That resistance is in parallel with the R2 thus the combination of the five and this resistor is equal to 1/(1/35.2+1/80) = 24.4Ω (3sf)
Now the total becomes this plus 2*R1

Total = 24.4+3.8*2 = 32.0Ω (3s.f.)

Just incase you were still stuck, that and I like to go back to some easy electronics now and again to remind me that my head hasn't exploded :)
 
You shouldn't give out the answers. We're not here to give solutions, but rather how to figure out a problem.
 
My Apologies, I was only going from what I saw in the rest of the forum.