Resistor Network Circuit Analysis

3 replies · 2K views · last reply
Dhooy7
Messages
33
Reaction score
0
Could someone help me with number 1. I think I did it wrong. I attached the diagram with the labels. On the original one the resistors aren't labeled, but I separately labeled them on my diagram.

1. R1=1.0 ohms
R2=3.0 ohms
R3=5.0 ohms
R4=12 ohms
R5=2.0ohms
R6=4.0 ohms
R=0.2 ohms
Vbatt=12.0 V

1. Homework Statement . I need to do determine the following:
a. Equivalent reistance
b current through the battery
c. The current through each resistor
d. the voltage on each resistor
e.the power used by each resistor

I really suspect I did something wrong.

Scan 11 is with the resistors labeled and breaking them down.
Scan 14 and 15 is of my work. If you can figure out what I did wrong that would be great!

Image 1 is of the initial problem.

Homework Equations

My equations are on the scans.

The Attempt at a Solution



I definitely attempted the solution on the scans attached.
 
Attachments
  • Handwritten lined-paper worked solution for a resistor network: battery current I_Batt = V_Batt/R_Batt = 12.0 V / 7.0 ohm = 1.71 A and I_Batt = I = I_1 = I_2345 = I_6 = 1.11 A, with boxed resistor currents and voltages.
    Scan0014.jpg
    46.7 KB · Views: 465
  • Handwritten resistor network analysis on lined paper titled "Problems 1 parallel" by Derrek Hooyman, showing circuit diagrams with resistors labeled R1 to R6, series and parallel reductions, and equations such as 1/R_p = 1/R3 + 1/R4 + 1/R5 and R_eq = 7.2 ohms.
    Scan0011.jpg
    47.2 KB · Views: 450
  • Handwritten circuit analysis on lined paper: voltage and current calculations such as V = 0.74A(3.0 ohm) = 2.22 V, V5 = 0.37A(2.0 ohm) = 0.74 V, then power values P = IV boxed at 1.23 W, 1.64 W, 13.32 W, 0.74 W, 0.37 W, 0.18 W, 0.27 W and a final P6 = 4.93 W.
    Scan0015.jpg
    47.8 KB · Views: 484
  • Circuit diagram of a resistor network with an 8.0 V source with internal resistance r, a 1.0 Ω resistor on top, 3.0 Ω and 4.0 Ω resistors, a 6.0 Ω resistor in parallel with a 12 Ω resistor, and a 2.0 Ω resistor, above a typed homework question.
    image1.PNG
    27.3 KB · Views: 517
Is R3 5 Ohms as you've listed in the problem statement or 6 Ohms as shown on the diagram?
 
Assuming R3 = 6Ohms..

Sheet 11 looks ok Req = 7.2R

Is Vbat 12V or 8V ?