Water Cooling System: Simple & Affordable Solution

AI Thread Summary
A Tunisian mechanical engineering student seeks an affordable method to cool water from an outdoor pool before it reaches three compressors. The student is exploring both low-power and high-power cooling solutions, including cooling towers, spray bars, and chillers. They are looking for simple and cost-effective options to implement during their internship. Resources on evaporative cooling and chiller basics have been shared for further reading. The student expresses gratitude for the assistance and plans to return with more questions.
YasmineBS
Messages
2
Reaction score
0
Hey everyone :)

I am a Tunisian Mechanical engineer student, doing my first practical internship. I need to find a way to cool water, that isn't expensive.

I have 'ambient heat' water that comes from an outdoor pool, then it goes to 3 different compressors, in order to cool them, then that same water goes back to the outdoor pool... and so on. I need to have a system that cools the water before it's arrival to the compressors.

I don't really know from what to start, what to read. It needs to be simple and not expensive.Many thanks !
 
Engineering news on Phys.org
Thank you so much, I will be reading them.
And I will come back if I have more questions.
Really helpful :)
 
Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
Back
Top