Why does using nodes V1 and Vo give wrong results in op-amp circuit analysis?

2 replies · 2K views · last reply
paulmdrdo
Messages
89
Reaction score
2
Thread moved from the technical forums, so no Homework Template is shown
In the problem below, when I use nodes V1 and V2 I get the correct answer of Vo = -2.5v
But when I use nodes V1 and Vo I get an incorrect answer. Please explain to me why my latter method did not work.
Thanks.

Circuit schematic with a 2 mA current source, resistors of 10 kΩ, 20 kΩ, 5 kΩ and 10 kΩ, and an op-amp with output Vo, nodes labelled V1 and V2, above handwritten node equations and the notes Vo = -2.5 V and Vo = 3.33 V.
 
Attachments
  • Circuit schematic with a 2 mA current source, resistors of 10 kΩ, 20 kΩ, 5 kΩ and 10 kΩ, and an op-amp with output Vo, nodes labelled V1 and V2, above handwritten node equations and the notes Vo = -2.5 V and Vo = 3.33 V.
    sadiku_p.5.14.png
    12.6 KB · Views: 909
Do you have all the currents going into node Vo?
 
I'd be happy to help if I could read your writing and if you showed where your equations come from.