Anyone thought of combining solar water heater with Stirling generator?

AI Thread Summary
Combining solar water heaters with Stirling generators could enhance electricity production by utilizing stored hot water, especially during the night. Solar water heaters are highly efficient at converting solar radiation into heat, while Stirling engines convert heat into mechanical energy, albeit with lower efficiency. Some experimental setups exist that use concentrating solar arrays and vapor compression cycles, but they typically only operate for a few hours post-sunset. Users have noted that while Stirling engines can generate motion, the overall power output is minimal compared to direct solar panels, which are more cost-effective and versatile. Interest remains in developing more efficient Stirling engines and exploring alternative waste heat engines for improved energy capture.
Ulysees
Messages
515
Reaction score
0
I've heard that solar water heating is very efficient, almost all the radiation of the sun on the panel is turned into heat.

Also heard Stirling cycle generators (where heat flow from hot to cold is turned into mechanical motion and hence into electricity) are also quite efficient. Though by no means as efficient as solar water heaters.

So what happens if you put the two together to produce electricity? You could use the stored hot water in the night too. It must be quite low-cost, certainly the solar panels and water tanks are mass-produced already, the cost is in the Stirling engine.

Anyone thought about this?
 
Engineering news on Phys.org
Although it isn't exactly like what you describe there are some experimental sites across the world, a couple in the Western deserts, that use the following concentrating solar arrays.

http://www.nrel.gov/csp/"

They generally run in a vapor compression cycle (a form of a Rankine cycle), however, and use steam turbines to capture the energy and convert it to mechanical work.

Everything I have read says that they work pretty well and are quite efficient but can only run a couple of hours after the sun has set. As far as the use of the Stirling engine I cannot comment.
 
Last edited by a moderator:
Also, check this out:
http://www.tfot.info/news/1101/the-rise-of-the-solar-tower.html
 
Last edited by a moderator:
It certainly works. You just don't get very much power out of it, due to the relatively low power/surface area ratio of incident sunlight, and the low specific power of a Sterling engine.
 
Can you just remind me what specific power is? Output power per kg of mass or something?
 
I meant power relative to physical size, but your definition is better. :smile:
 
Check this out

This will provide 3 KW of electric power in bright sunlight plus all the hot water you need.

http://www.infiniacorp.com/applications/Prod_Spec.pdf


Hubert
 
You can also visit http://www.eecs.berkeley.edu/~artin and take a look at Artin Der Minassians' dissertation and publications.
 
Last edited by a moderator:
It sure is possible
you can get motion out of a flate plate collector i used a flate plate collector + LTD stirling engine, it runs. Check it out on video google under solar engine or link to
http://video.google.com/videoplay?docid=-6257236920067550362
 
Last edited by a moderator:
  • #10
Sounds like a good idea, but here is my experience:

My father has a stirling engine, I made an experiment with this stuff back in high school. The water was really hot, like 90°C almost. Even the striling started to move, the real turn was when the motor was exposed to direct flame. And with the loss of energy of the mechanical transmission from the stirling engine to a generator the current that could be obtained was minimal.

I compared this result later when I was working with alarm systems using solar panels. Using a solar panel is more effective and cheaper in the long run compared to what can be obtained of the solar panel. And as you can consider using batteries you can use the obtained energy anytimne you want to. I don't know if now a more efficient stirling engine can be obtained to compare with what's available nowadays.
 
  • #11
Where can one acquire a large sterling engine or an engine using the same concepts (a waste heat engine)? I am interested in focusing large/many fresnel lenses and using the heat from the focused beams into electricity and work.

Here is a cool company but I cannot seem to find out if any of their products are for sale. http://cyclonepower.com/waste_heat_engine.html
 
Last edited by a moderator:
Back
Top