Calculating Electron Trajectory in a Parallel Plate Conductor

3 replies · 3K views · last reply
laurajean997
Messages
2
Reaction score
0

Homework Statement



An electron is fired at a speed vo = 5.6 ✕ 10^6 m/s and at an angle θo = -40° between two parallel conducting plates that are D = 2.5 mm apart, as in Figure P16.66. The voltage difference between the plates is ΔV = 103 V.

Diagram of an electron's curved path between two horizontal parallel conducting plates, with the electron entering at the origin at angle θ0 below the x-axis and deflecting upward, labelled v0, D, d, ΔV and the x and y axes.


Homework Equations



F = Eq

E = V/d

a = F/m

The Attempt at a Solution



I tried finding acceleration with (ΔV/D)(q/m) or 103/.0025 * 1.6e-19/9.11e-31

I found Vy with 5.6e6sin(40)

Then i used vyf^2 = vyo^2 + 2aΔy to solve for Δy

then i subtracted my answer from .00125 m and got .54 mm, but the website says I'm off by more than 10%.

I haven't tried part B yet because i could have acceleration wrong and that will just mess up both answers.
 
Last edited:
Don't forget gravity, or at least check how it compares with the acceleration of the electric field.
Write down equations, instead of narrating your calculations.
 
The acceleration was something x 10^15 so i figured gravity was negligible.
 
laurajean997 said:

Homework Statement



An electron is fired at a speed vo = 5.6 ✕ 10^6 m/s and at an angle θo = -40° between two parallel conducting plates that are D = 2.5 mm apart, as in Figure P16.66. The voltage difference between the plates is ΔV = 103 V.

Diagram of an electron entering between two parallel plates at angle θ0 from the origin with velocity v0, curving downward then upward along a dashed path; plate separation D, gap d, battery ΔV, and x and y axes shown.


Homework Equations



F = Eq

E = V/d

a = F/m

The Attempt at a Solution



I tried finding acceleration with (ΔV/D)(q/m) or 103/.0025 * 1.6e-19/9.11e-31

I found Vy with 5.6e6sin(40)

Then i used vyf^2 = vyo^2 + 2aΔy to solve for Δy

then i subtracted my answer from .00125 m and got .54 mm, but the website says I'm off by more than 10%.

I haven't tried part B yet because i could have acceleration wrong and that will just mess up both answers.

Hi laurajean997. Welcome to Physics Forums.

Can you show your attempt in a bit more detail? In particular, show the values that you obtained for the intermediate steps.