Circuits: Solve Using Nodal and mesh Analysis

3 replies · 5K views · last reply
Saladsamurai
Messages
3,009
Reaction score
7

Homework Statement


Problem statement text: 2.2.4 Use the node-voltage method to determine the voltage across the 12-Ω resistor of the circuit given in Figure P2.2.4. Verify by mesh analysis.

Circuit schematic with a 144 V source in series with a 3 Ω resistor on the left, a 4 Ω resistor on the top branch, a 4 Ω and 8 Ω resistor along the middle branch, a 2 Ω resistor in the centre vertical branch, and a 12 Ω resistor on the right labelled with voltage V, captioned Figure P2.2.4.




Homework Equations


KCL & KVL:


The Attempt at a Solution



Ok folks :smile: I am not sure where to go from here. Someone suggested changing the 144V to its Thevenin equivalent, which I have done below. I know that I am supposed to apply KCL at each node A,B, and C. And then I represent each current in terms of voltages. Now I am a little confused as to how to proceed.

I am trying got convince myself that R1, R2, and R3 are in parallel because their leads are all connected, but I am not sure yet. The voltage drop across R1 is definitely just VA since I can pass from A across the resistor and directly to ground. But for R2 and R3, I feel like the voltages at B and C need to be considered.

Any thoughts?


Handwritten node-voltage circuit schematic labelled 2.2.4 with nodes A, B and C, a 48 A current source, resistors 3 ohm, 4 ohm, 2 ohm, 3 ohm, 12 ohm and 4 ohm, voltage V across the 12 ohm resistor, and reference node O at the bottom.
 
I think you meant to say that you've changed the voltage supply and its series resistance to its Norton equivalent.

Also, one leg in common does not a parallel connection make; R1, R2, and R3 are not in parallel.

With the network as shown in your second diagram, you are in a position to write the node voltage equations by inspection.
 
gneill said:
I think you meant to say that you've changed the voltage supply and its series resistance to its Norton equivalent.

Also, one leg in common does not a parallel connection make; R1, R2, and R3 are not in parallel.

With the network as shown in your second diagram, you are in a position to write the node voltage equations by inspection.

So they are not in parallel because they do not share the same voltage, correct?

I think I have it now:

Node A:

[itex]48 - V_A/3 - (V_B - V_A)/4 - (V_C - V_A)/4 = 0[/itex]

Node B:

[itex](V_B - V_A)/4 - (V_C - V_B)/3 - V_B/2 = 0[/itex]

Node C:

[itex]-V_C/12 + (V_C - V_B)/3 + (V_C - V_A)/4 = 0[/itex]

Now I need to move forward to the mesh analysis.
 
For components to be in parallel, both ends of each need to be directly connected to each other.

It looks like you're on the right track. Keep up the good work!