Clamp force divide by surface ?

AI Thread Summary
Clamp load values for bolts and screws are typically not divided by two, as they represent the total force applied to the joint. When simulating in SolidWorks, the force applied to a surface should reflect the total clamp load, not halved. If two screws are used to connect two surfaces, the total clamp load can be considered as the sum of the loads from both screws, effectively doubling the force. It's important to accurately represent these forces in simulations to understand how the surfaces will respond. Properly accounting for clamp loads is crucial for accurate results in mechanical simulations.
joshua
Messages
2
Reaction score
0
hi, newbies here !

found clamp load in some catalogue for bolt and screw.

is that value should divide by 2 since bolt is connect 2 surface together ?

by the way, i am try to solidworks simulation,
want to apply force on a surface to see how it respond on that surface
both surface/body is same material
 
Engineering news on Phys.org
another question here:
what if these 2 surfaces are connect with 2 screw
do i multiply the clamp load by 2 again ?
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
View full post »

Similar threads

Automotive Topology optimization of an engine's cylinder block
Replies
14
Views
776
Analytical verification of FEA involving preloaded bolt
Replies
9
Views
2K
Forces applied on the bolts in the bike's hinge
Replies
36
Views
3K
Determine how many bolts are needed to secure a block of steel
Replies
1
Views
2K
Calculating if a Pipe Clamp will slip
Replies
2
Views
10K
Vacuum bag vs bolt force (fabricating a carbon fiber wing)
Replies
1
Views
1K
Reusability of nuts and tapped holes + Choosing the right material
Replies
3
Views
2K
I Will This Friction Clamp Hold the Weight?
Replies
10
Views
2K
Difference in clamping force between bolts and screws
Replies
5
Views
3K
I Understanding Bolted Joints: Shigley's Explanation & Real-Life Testing
Replies
8
Views
3K

Hot Threads

Recent Insights

Back
Top