Converting orthographic drawings to isometric projection

  • Thread starter bawse
  • Start date
  • Tags Tags
    Drawing
2 replies · 2K views · last reply
bawse
Messages
11
Reaction score
0
Hi,

So I've just recently transitioned from converting isometric drawings --> orthographic to orthographic --> isometric and I am having quite a bit of difficulty with the latter

I have attached the question and my attempt at it (hardly anything because I am having trouble visualising how the component looks like.

Any help would be appreciated

cheers
 
Attachments
  • Orthographic projection drawing on grid paper with a top view containing a circle and an angled slanted edge, and a front view and side view below, labelled A, dimensions W7xD5xH3.
    IMG_1146[1].jpg
    52.9 KB · Views: 646
  • Isometric pencil drawing on dotted isometric grid paper of a solid block with a rectangular notch cut from its front-right corner, marked with a point labelled A at the bottom.
    IMG_1147[1].jpg
    59.7 KB · Views: 601
since my original post, I have fiddled around and seemed to come to a drawing that looks closer to the answer. Could anyone tell me if I am on the right path? And also in the attachment, the portion circled doesn't look right to me, but I don't know how to make it seem 3D. Any help would be appreciated

Thanks
 
Attachments
  • Isometric line drawing on dotted isometric grid paper of a rectangular block with a slot cut into its front right side, circled in red.
    IMG_1148.jpg
    60.6 KB · Views: 643
The way you have the isometric drawn, you show the angled notch in the near corner of the object extending the full depth, which is not what the ortho projections indicate: the lines on the bottom should be invisible.
 
  • Like
Likes   Reactions: 1 person