Gyroscope behaviour during 24 hours on earth

  • Level: Graduate 
  • Thread starter aladinlamp
  • Start date
  • Tags Tags
    Earth Gyroscope
3 replies · 4K views · last reply
aladinlamp
Messages
44
Reaction score
1
Hi

is my assumption correct ?

precision gyroscope,sitting on the table during 24 hours, perfectly balanced, with free motion in all 3 axis, while still spinning using electric drive or compressed air to maintain motion...

there should be relative motion between gyro and its stationary holder in all 3 axis( assuming I am not at the poles) but at some latitude less than 90.

gyro disk should keep orientation and holder will move with earth, but from my reference frame i will see holder stationary and gyro disk will move

Slide titled Gyroscope showing a labelled diagram of a gyroscope with gyroscope frame, spin axis, gimbal and rotor, next to a diagram with X, Y and Z axes and a rotor inside a gimbal ring; text describes a free gyro.
Diagram of Earth showing axial tilt (obliquity) between the perpendicular to orbit and the rotation axis, with the celestial equator and ecliptic planes, north and south celestial poles, and the orbit direction arrow.
Diagram of Earth viewed from above the North Pole showing four positions around the globe labelled initial/24, 6, 12 and 18 o'clock, each with a rectangular block marked E and W, plus a compass rose with N, S, E and W.
 
Right.

Not necessarily a motion in all 3 axes, it depends on the orientation of the axes relative to the rotation axis of Earth.
 
i think because of tilted Earth axis, except poles, the point on the sphere surface( gyro holder) has to move in all 3 axis
 
Tilt relative to an arbitrary reference frame?
You can consider everything from the reference frame of Earth, aligned with the axis of rotation.