Modulus of elasticity, problem. Graph and table.

2 replies · 4K views · last reply
MMCS
Messages
151
Reaction score
0
Attached is the graph and small part of table that i have chosen from the elastic range (first column extension, second column load) from a tensile test. I am trying to calculate youngs modulus of elasticity but can't seem to get a figure close to that of the common figure for the material

Material 0.1% carbon steel
Area = 20 x 10-6m2
Yield force = 6009N
Length increase at yield force = 0.537mm = 0.000537m
Original length = 50.mm = 0.05m


E = σ/ε

E = (6006/20x10-6) / (0.000537/0.05)
E = 27.96 x 109
Typical value = 207 x 109

Iv obviously went very wrong somewhere but i don't know where

Thanks
 
Attachments
  • Left: force against displacement graph titled Carbon Steel, rising to a peak near 6000 N, dropping slightly, then rising to about 8000 N before falling near 10.7 mm. Right: spreadsheet rows of timestamps, displacement and load, with one row highlighted.
    Untitled.png
    43.4 KB · Views: 673
For a start, send again but include the units at every step (as is good practice).
 
Are you certain that the original length of the wire was 50mm and not 50cm?