Need to write a research proposal

  • Thread starter Thread starter insanemembrane
  • Start date Start date
  • Tags Tags
    Research
AI Thread Summary
The discussion revolves around the need to write a research proposal for a module on Research Methods, with the participant seeking topic ideas. They clarify that this proposal is distinct from a previously discussed dissertation project and emphasizes the broader scope available since no actual research will be conducted. The participant is looking for suggestions that could inspire a compelling proposal. The conversation highlights the importance of generating innovative research topics in academic settings. Engaging with peers for ideas can enhance the proposal's quality and relevance.
insanemembrane
Messages
4
Reaction score
0
Hey guys,

I have to write a research proposal for one of my modules (Reseach Methods) this year, I don't actually have to do the research. I was wondering if anyone had any ideas for topics or areas that would be good to look into?
 
Engineering news on Phys.org
insanemembrane said:
Hey guys,

I have to write a research proposal for one of my modules (Reseach Methods) this year, I don't actually have to do the research. I was wondering if anyone had any ideas for topics or areas that would be good to look into?

Is this the same question that you already asked? https://www.physicsforums.com/showthread.php?t=717585

.
 
They certainly are similar questions but I have since been allocated a project for my dissertation. This research proposal is simply just a proposal for a different module and I believe there is a much broader scope for the amount of work that could be done as I don't actually have to conduct the research myself.
 
Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
Thread 'What's the most likely cause for this carbon seal crack?'
We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
Back
Top