Non-Ohmic Device Study: I-V Graphs and Light Bulb Analysis

  • Thread starter negat1ve
  • Start date
  • Tags Tags
    Device
1 reply · 12K views · last reply
negat1ve
Messages
23
Reaction score
0
For a lab yesterday we recorded points to plot the I-V graphs for a few resistors and a light bulb. The light bulb was supposed to show that some that some devices don't obey ohms law but when plotting the graph I am cutting more of a straight line then a curve showing that it DOES! Could this be because are voltage and current results came from a low power source that only dimly lit the bulb not giving it a chance to heat up? Or is this an error? How do i report this result>
 
negat1ve said:
For a lab yesterday we recorded points to plot the I-V graphs for a few resistors and a light bulb. The light bulb was supposed to show that some that some devices don't obey ohms law but when plotting the graph I am cutting more of a straight line then a curve showing that it DOES! Could this be because are voltage and current results came from a low power source that only dimly lit the bulb not giving it a chance to heat up? Or is this an error? How do i report this result>

Well for low current the filament won't heat much, so you won't read much difference. But if it is glowing at least it is pretty hot. If you put a resistor in series with the bulb you can measure the voltage across that with the bulb and without the bulb. Then you could measure the bulb alone with very low current of the voltmeter and demonstrate that its heated R is greater than its cold R.