OP07 Schmitt trigger with ±1V thresholds and ±12V supply

  • Thread starter revird163
  • Start date
  • Tags Tags
    Op-amp
3 replies · 2K views · last reply
revird163
Messages
1
Reaction score
0
Poster has been reminded to post schoolwork in the HH forums and use the HH Template in the future
I have been been trying to search forums and figure out the following question that I just cannot seem to get my head around!

Design a Schmidt comparator circuit based on an OP07 operational amplifier with the following characteristics: Power supply Voltages: +/- 12V Switching thresholds +1V, -1V

I have been trying to figure out the voltage saturation and then using this to find the resistor values for the schmidt trigger. I cannot work out what the voltage saturation is and how to calculate it at all.

Any help would be appreciated, I am really not the best at electronics!

The following is the circuit I am trying to use modeled on LTSpice:
LTspice schematic of an OP07 op-amp (U1) with a 12 V sine source V1 (SINE(0 12 1000)) on the non-inverting input, a 100k feedback resistor R2 from output to inverting input, and a 10k resistor R1 to ground; a separate 12 V DC source V2 and the directive .tran 0 0.01 0 0.001 are shown.
 
Consider that you have both +V and -V available since they're powering the op amp. You can tie the bottom of your R1 to -V rather than ground, and add another resistor of the same size as R1 to tie the + input to +V as well. Then tinker with your R2 value to adjust the total spread of the triggers. By symmetry the trigger points should lie on either side of the midpoint between +V and -V, or in other words, 0 V.
 
revird163 said:
I have been been trying to search forums and figure out the following question that I just cannot seem to get my head around!

Design a Schmidt comparator circuit based on an OP07 operational amplifier with the following characteristics: Power supply Voltages: +/- 12V Switching thresholds +1V, -1V

I have been trying to figure out the voltage saturation and then using this to find the resistor values for the schmidt trigger. I cannot work out what the voltage saturation is and how to calculate it at all.

Any help would be appreciated, I am really not the best at electronics!

The following is the circuit I am trying to use modeled on LTSpice:
Welcome to the PF.

I would make the power supply rails using two separate sources. Otherwise their relationship to ground can be ambiguous... :smile: