Poster Hanging on Brick Wall: Best Techniques

[Physics is Phun]

so I have a brick wall in my room I want to put a poster on. it's the regular small house brick, a chimney to be exact. I've used sticky tack and tape. both hold for a bit and let go after a couple weeks.
what would you use?

 

[Evo]

so I have a brick wall in my room I want to put a poster on. it's the regular small house brick, a chimney to be exact. I've used sticky tack and tape. both hold for a bit and let go after a couple weeks.
what would you use?

Would you be able to put some clear sealant over the brick at the spots where you would attach the poster? I would suggest brushing the brick first to remove any grit or dust. Once you have a non-porous surface, the sticky tack should hold.

 

[Danger]

You can also drill holes into the bricks and install concrete or drywall anchors. Mount a solid board of some sort using those, and stick your poster to the board.

 

[Kurdt]

pva glue should work but it may damage the poster when you come to take it down.

 

[Mk]

Sand the area down under the poster so that it is nice and smooth.

 

[Cyrus]

Bricks suck up moisture, that's why the tape is getting lose.

 

[Mk]

Bricks suck up moisture, that's why the tape is getting lose.

Yeah, always keep your tape good and wet.

 

[Danger]

Yeah, always keep your tape good and wet.

More than a few 'ban-worthy' responses to that come to mind...

 

[FredGarvin]

Have you tried any of the adhesive puttys that are out there? I think 3M makes the stuff I have seen before.