[SOLVED] Cone suspended on power line, between 2 poles

  • Thread starter Thread starter Trikenstein
  • Start date Start date
  • Tags Tags
    Power lines
Click For Summary
The discussion centers on objects suspended on power lines near an airfield, specifically identifying an orange cone and aerial marker balls. The orange cone is believed to serve as a navigation marker for a temporary grass landing strip aligned with the new runway. The aerial marker balls indicate the power line's presence, enhancing safety for aircraft operations. The context includes concerns about airfield improvements and fill operations at the Tottenham/Volk airfield. Overall, the cone and markers are crucial for ensuring safe navigation in the area.
Trikenstein
Messages
21
Reaction score
9
Hi,

The photo shows some objects suspended on a power lines near an airfield

objects_between_powerlines.jpg


Here is the location of those objects on a map:
Objects_between-powerlines_onMap.jpg


The 3 pink circles are the oranges balls in the photo. Which seem to be Aerial Marker Balls.

QUESTION: The pink triangle is the cone shown in the photo. What is this cone and what is its usage?
 
Last edited:
Engineering news on Phys.org
"The Tottenham/Volk airfield was purchased by a fill operator, under the guise that they need to bring in millions of cubic metres of commercial fill to improve a grass airfield." (Extract from the opening to a petition to stop fill and airfield improvement).
A temporary? grass landing strip has been built on earlier fill, 270 metres west, parallel with the original strip, while the old strip area is being filled.

The orange cone is in direct alignment with the new grass landing strip. The cone is on the upper wire. The balls mark the same power line, but across the end of the original runway. That suggests it is a cable warning marker, and a navigation marker, for the centre of the new (temporary?) runway.
 
  • Informative
Likes berkeman and phinds
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...