Transistor and capacitor circuit analysis with combined branches

  • Topic: Engineering 
  • Thread starter moogoescow
  • Start date
  • Tags Tags
    Circuit
2 replies · 2K views · last reply
moogoescow
Messages
1
Reaction score
0
1. For a mini-assignment at school, we were asked to find a circuit using transistors and capacitors and build it, then analyse the differences when a variable is changed. The circuit me and my partner chose is as follows:
Schematic of a astable multivibrator with two 2N2222 NPN transistors Q1 and Q2, cross-coupled through C2 110uF and C1 100uF, with R3 and R2 10kΩ base resistors, LED1 and LED2, R1 390Ω, diode D1 1N4001, and a 9 V supply V1.

We got our experimental values, but had a lot problems calculating them theoretically, because the branches combine and such, so we weren't really sure how to approach it.
2. The only equation involved would probably be Ohm's Law. It seems pretty basic, but we just can't seem to get it.
3. As I stated above, we tried all we could but we just couldn't find a way to approach it as to get all of the different values.

Any and all help is appreciated.
 
moogoescow said:
1. For a mini-assignment at school, we were asked to find a circuit using transistors and capacitors and build it, then analyse the differences when a variable is changed. The circuit me and my partner chose is as follows:
Schematic of a astable transistor multivibrator with two 2N2222 NPN transistors Q1 and Q2, cross-coupled capacitors C2 110uF and C1 100uF, base resistors R3 and R2 10k ohm, collector LEDs LED1 and LED2, a 390 ohm resistor R1, a 1N4001 diode D1, and a 9 V battery V1, with numbered nodes 1 through 8.

We got our experimental values, but had a lot problems calculating them theoretically, because the branches combine and such, so we weren't really sure how to approach it.



2. The only equation involved would probably be Ohm's Law. It seems pretty basic, but we just can't seem to get it.



3. As I stated above, we tried all we could but we just couldn't find a way to approach it as to get all of the different values.

Any and all help is appreciated.

Where is this circuit from? It looks like it's trying to be a multivibrator, but there is no means for starting the oscillation. What were your experimental results? Did you have an extra mechanism like a switch (not shown) to start up the oscillations?