Vibrational Modes: How They Affect Motion

  • Thread starter Thread starter Kajan thana
  • Start date Start date
  • Tags Tags
    Modes
AI Thread Summary
The discussion centers on the interpretation of vibrational modes in relation to accelerometer data from a Bimorph beam (PEH). The "Predicted" graph is believed to be generated using Finite Element Analysis (FEA) tools, while the "Measured" graph reflects actual data collected from experiments. The setup likely involved exciting the MEMS arm with a high mechanical impedance source and varying the frequency to obtain the results. This approach is analogous to plotting the transfer function of a two-port network. Understanding these graphs is crucial for analyzing the vibrational behavior of the system.
Kajan thana
Messages
149
Reaction score
18
TL;DR Summary
I understand the basic meaning of vibrational mode. Could someone interpret what this graph means?
1637767754603.png

Ps: It is not a homework hence why I did not leave it under that headline.
 

Attachments

  • 1637767671004.png
    1637767671004.png
    7.6 KB · Views: 128
Engineering news on Phys.org
What is the test setup? Is this accelerometer data?
 
This data is on Bimorph beam (PEH)...
 
Kajan thana said:
This data is on Bimorph beam (PEH)...
Oh, like this: https://www.google.com/url?sa=t&rct.../8/4/645/pdf&usg=AOvVaw2DBGVt6_5h1-fJ0Yv-EqoI

Kajan thana said:
Summary:: I understand the basic meaning of vibrational mode. Could someone interpret what this graph means?
So the "Predicted" graph was likely plotted using FEA tools, and the "Measured" graph was plotted directly from the acquired data. Presumably they were exciting the MEMS arm with a high mechanical impedance source and sweeping the frequency of that source to get the plot. Similar to how you plot the transfer function of a 2-port network...
 
  • Like
Likes Kajan thana
Thank you so much
 
Thread 'Turbocharging carbureted petrol 2 stroke engines'
Hi everyone, online I ve seen some images about 2 stroke carbureted turbo (motorcycle derivation engine). Now.. In the past in this forum some members spoke about turbocharging 2 stroke but not in sufficient detail. The intake and the exhaust are open at the same time and there are no valves like a 4 stroke. But if you search online you can find carbureted 2stroke turbo sled or the Am6 turbo. The question is: Is really possible turbocharge a 2 stroke carburated(NOT EFI)petrol engine and...
I need some assistance with calculating hp requirements for moving a load. - The 4000lb load is resting on ball bearing rails so friction is effectively zero and will be covered by my added power contingencies. Load: 4000lbs Distance to travel: 10 meters. Time to Travel: 7.5 seconds Need to accelerate the load from a stop to a nominal speed then decelerate coming to a stop. My power delivery method will be a gearmotor driving a gear rack. - I suspect the pinion gear to be about 3-4in in...
Back
Top