What Happens When You Inverse Transform Impedance Back to Time Domain?

  • Thread starter Thread starter tandoorichicken
  • Start date Start date
  • Tags Tags
    Impedance
Join the discussion
Registration is free. Ask a follow-up in this thread, or start your own.
Sign up Log in
4 replies · 11K views
tandoorichicken
Messages
245
Reaction score
0

Homework Statement


This is a general question regarding impedance in circuit analysis.
I know that in order to find the total impedance of a circuit, you transform each element characteristic into the frequency domain, i.e.,
[tex]R\rightarrow Z_R = R[/tex],
[tex]C\rightarrow Z_C = \frac{1}{Cs}[/tex],
[tex]L\rightarrow Z_L = Ls[/tex].

And then sum up the quantities properly to get an equivalent impedance.

My question is, what happens if you transform this quantity back using an inverse transform? Do you get a real resistance value?
 

Discussion

Physics news on Phys.org
This transformation doesn't have an inverse for the imaginary part, since the effect of capacitor and inductance cancel out each other...

The resistance value is the real part of the impedance... ie Re(Z) = R,
 
what if its a circuit consisting of only a resistor and a capacitor?
 
tandoorichicken said:
My question is, what happens if you transform this quantity back using an inverse transform? Do you get a real resistance value?

well, why would you expect that in general you get just a purely resistive circuit when you started with a circuit with a resistor, a capacitor and an inductor?

The property of the circuit won't change just because you have tranformed into a more convenient domain (the freq domain in this case) for calculation purposes and then changed it back. If you begin with a 1 ohms and a 2 ohms resistor, then you can say ok, the total R is 3 ohms, so I can replace them with just one 3 ohms resistor. But that's all you have really done in finding the equivalent resistance.

same applies in the case with capacitors and inductors included. you started with R , C, L. Since C and L make up the imagary part (in freq domain) they have a chance to cancel (fully or partially). If they cancel each other fully, then you will end up having just an R in your equivalent circuit. Now if they don't cancel fully you will have either one L or one C (of different value) left pending on the phase of the equivalent resistance in freq domain.
 
In the time domain you can only calculate the impedance of the circuit for specific frequencies. At the resonant frequency, you have a pure resistance, below or over the resonant frequency, you have complex impedances, either RC or LC.
If you have a closed circuit, with sources and/or initial conditions, you can solve the resulting differential equation and have a frequency independent solution.