Xbee Pro 900 stops displaying accelerometer data after 20 seconds

[NATURE.M]

So quick question: Basically I have my xbee pro 900 configured to an Arduino to read data from an accelerometer. The data will then get displayed in the xctu console on my computer transmitted wirelessly of course. Now I did this same procedure with a temp. sensor and the data was displayed perfectly. This time I'm getting data transmitted from the accelerometer, however after so many lines(or about 20 sec) it stops displaying data in the console. Now I'm not sure if its overloading the console with to much data or if there's another possible issue. The "on" led on the xbee begins to flicker on and off afterwards as well. I don't understand why this happens. Any suggestions on possible sources of error are greatly appreciated.

 

[anorlunda]

We would have to see your circuit, the identity of sensor component, and the arduino code to answer that.