The driver is not going to get its power supply from the micro controller, its only getting its input logic from the micro controller. Its not powering anything, I just want to see the 25v ac on an oscilloscope. So I''ll just put a resistor as the load. It is supposed to simulate a solar panel...
I have been tying to design and build a dc to ac inverter. I want to convert 10v dc to 25v ac @ 50hz. I want to use a pic24h microcontroller to generate pwm waveforms to control a H bride driver. I have programmed the pic24h to produce pwm waveforms. I used the LMD18200 as the h bridge driver...