Yes, that's right. I believe the shaft is more than capable of withstanding the torque. The question is focused on the end connection and at what point it would be stripped out.
The problem lies in the fact that whatever connection method I choose (square drive / hex etc.) I must be able to...
I did read that thread earlier today, but its not so much the shaft that I need to know about, more the end fitting.
I "think" I'm right in saying that the torque capabilities of a shaft are different to those of a square / hex. Again, I "think" I need a calculation which takes into account...
Hi all,
I'm hoping this is a relatively simple question, but the usual Google search has not really offered me any hints ?
I need to make a shaft with a connection at one end. The type of connection is not critical as the shaft it will connect to is to be specially made as well. So, I...