Hello all!
I am carrying out the theoretical (that is, by calculation means) unsymmetrical fault calculations for three winding transformer.
It is to my understanding that for the zero sequence impedance for a three winding transformer depends on the winding connections of the generator and...
Hello all!
I'd like to clarify on the the differences of bipolar and unipolar voltages. I do understand that they both are used to trigger a number of semiconductor devices.
Please and thank you!
Hello all, would like to ask what seems to be a general rule when designing power systems.
In the power system design program which I just started to use. It is advised that:
For every simulation to be run, it is best to have a "flat start" before running any faults.
I'm not too sure...
Hello everybody,
I'm a bit confused about the concept of solidly grounded tranformers. From my understanding, the wye connection of the transformer side would be followed by a resistor of a certain magnitude.
Hopeful that my doubt would be clarified.
Thanks!
Hello! This is my second post about sequence reactances. This time- its in induction motor.
To my understanding ( once again ) -
In any network (symmetrical or unsymmetrical) , there would be 3 components- positive sequence component, negative sequence component and zero sequence...
Hi all! I am currently learning fault study in power systems.
To my understanding-
In any network (symmetrical or unsymmetrical) , there would be 3 components- positive sequence component, negative sequence component and zero sequence component.
Question:
For generators and transformers ...