Relationship between temperature and resistance

AI Thread Summary
The discussion focuses on establishing the relationship between resistance and temperature using Nichrome wire. Participants are struggling with circuit setup and are unsure if their current configuration, which involves a power pack and heating the wire, is correct. Suggestions include connecting an ammeter in series and a voltmeter in parallel for accurate measurements. Additionally, using a thermistor as a temperature sensor is recommended for better data collection. Overall, assistance with circuit diagrams and measurement techniques is sought to successfully conduct the experiment.
Sir Pwn4lot
Messages
4
Reaction score
0
1. Well, we want to find the relationship between resistance and temperature. We asked the lab techie and he said to use some Nichrome wire in a coil and test the potential difference, current and temperature of the wire.

We're having a problem getting it set up. We're not sure how to set up the circuit.




2. N.A.



3. We've tried having a power pack that goes into the wire then back into the power pack, and the wire gets hot. Are we doing this right? Could someone please help us out with a circuit diagram or something?


Thanks a lot guys.
 
Physics news on Phys.org
1. Well, we want to find the relationship between resistance and temperature. We asked the lab techie and he said to use some Nichrome wire in a coil and test the potential difference, current and temperature of the wire.

We're having a problem getting it set up. We're not sure how to set up the circuit.




2. N.A.



3. We've tried having a power pack that goes into the wire then back into the power pack, and the wire gets hot. Are we doing this right? Could someone please help us out with a circuit diagram or something?


Thanks a lot guys.
 
Connect the ammeter in series and the voltmeter in parallel. Not too sure how you plan to measure temperature though. Unless you have a resistor that is affected by temperature.
 
I think this pdf might help you: http://www.owlnet.rice.edu/~phys102/Lab/expt03.pdf

It is the lab manual for a resistivity experiment for PHYS 102.

Cheers.
 
Last edited by a moderator:
Maybe you could use a thermistor as a temperature sensor.
 
Kindly see the attached pdf. My attempt to solve it, is in it. I'm wondering if my solution is right. My idea is this: At any point of time, the ball may be assumed to be at an incline which is at an angle of θ(kindly see both the pics in the pdf file). The value of θ will continuously change and so will the value of friction. I'm not able to figure out, why my solution is wrong, if it is wrong .
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Back
Top