Using OTA as an Integrator for Dual Slope ADC: Advice & Links

Thread starter salil87
Start date Sep 2, 2013

AI Thread Summary

Using an Operational Transconductance Amplifier (OTA) as an integrator in a dual slope ADC involves charging a capacitor with the signal output current and discharging it with a reference current. The placement of the capacitor is the primary distinction when integrating an OTA compared to traditional methods. For further understanding, reviewing the dual slope A/D article on Wikipedia is recommended. Clarification on specific aspects of the integration process may be needed for more detailed guidance. Overall, utilizing an OTA can enhance the performance of dual slope ADC designs.

Sep 2, 2013

salil87

Hi
I just want to get some idea how to use an OTA as an integrator (for dual slope ADC). Can some one help me out or give me some links?
Thanks
Salil

Engineering news on Phys.org

Sep 2, 2013

meBigGuy

Gold Member

You charge a capacitor with the signal output current, and then discharge it with the reference. Not really sure what you are asking. Read the dual slope A/D article at wikipedia. I think the only difference with an OTA is where you put the capacitor.

Thread 'How might electronics be different if AC voltage was 72V at 45 Hz?'

Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?

View full post »

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...

View full post »

Thread 'Why does the amperage go real high if there is a low voltage short?'

I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...

View full post »