also I it would be best if I could show the results of the PSD plots as a smooth line by putting some kind of line of best git through the pwelch values obtained.
Any advice on the above 2 questions will be much appreciated since I have to find a way of doing this into show my results by the...
Hi,
I am simulating vibrations in simulink and processing my results in matlab. I am trying plot the PSD for my acceleration results using pwlech method.
When I plot the PSD plots from the methods below
(NOTE:I have a sampling rate of 0.006 so that means I am using a sample frequency of...
Hi Viscousflow thanks for the reply. The saturation block was what I was describing but unfortunately I didn't think through the problem I was modelling properly and a simple saturation block will not work.
I am modelling Semi active damping with skyhook control. (MR damper with 2 DOF)
I want...
I am modelling the vibration of a 2 D.O.F system with damping in Simulink.
I want to set up control such that if the control value is between two values (max and min) then it sets the control value to the specified input but if it is outside the max and min interval then the control value is...
I am modelling the vibration of a 2 D.O.F system with damping in Simulink.
I want to set up control such that if the control value is between two values (max and min) then it sets the control value to the specified input but if it is outside the max and min interval then the control value is...