Insights Blog
-- Browse All Articles --
Physics Articles
Physics Tutorials
Physics Guides
Physics FAQ
Math Articles
Math Tutorials
Math Guides
Math FAQ
Education Articles
Education Guides
Bio/Chem Articles
Technology Guides
Computer Science Tutorials
Forums
Trending
Log in
Register
What's new
Latest activity
Register
Menu
Log in
Register
Navigation
More options
Style variation
System
Light
Dark
Contact us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Baluncore's latest activity
Baluncore
replied to the thread
Electromagnet magnetic field issue
.
You should try soft iron or mild steel for the pin, not stainless or high tensile steel. The more the pin material costs, the worse it...
Sep 17, 2025
Baluncore
replied to the thread
Electromagnet magnetic field issue
.
Yes, check the current tomorrow. Maybe the 12 V supply has insufficient voltage under load. Is the pin made from iron, steel, or maybe...
Sep 17, 2025
Baluncore
replied to the thread
Electromagnet magnetic field issue
.
Is it using an AC or DC supply ? Is the wire the same gauge or diameter ? Can you measure the coil current ?
Sep 17, 2025
Baluncore
replied to the thread
Automotive
Motor for slider crank
.
There are too many possibilities. Almost any small electric motor will do the job. How you construct the slider crank, and mount the...
Sep 16, 2025
Baluncore
replied to the thread
B
Could we ever create a black hole?
.
So you want a handy 1 kg black hole to pass around the classroom ? It will be smaller than a normal proton, how will you hold it ? How...
Sep 16, 2025
Baluncore
replied to the thread
I
The Physics of unloading sand from a barge
.
Vibration is used to remove air bubbles from concrete, and would separate excess water from more dense sand, thickening the fluid. The...
Sep 15, 2025
Baluncore
replied to the thread
I
The Physics of unloading sand from a barge
.
You start with the pump input pipe resting at a low point on the surface.
Sep 15, 2025
Baluncore
replied to the thread
I
The Physics of unloading sand from a barge
.
The sand in the barge was initially saturated. The pump inlet was placed on top of the load at the start, then the hoses were used to...
Sep 14, 2025
Baluncore
replied to the thread
B
Why can't Solar panels be hemispherical, or a curved strip type?
.
On pitched roofs, we have a constraint that requires the panels not protrude significantly beyond the existing roof profile. That...
Sep 13, 2025
Baluncore
replied to the thread
I
Off resonance driving of a MW/RF cavity
.
At 100 MHz, the 10 GHz cavity would be well below the cut-off frequency. Depending on the cavity coupling technique, it would appear as...
Sep 13, 2025
Baluncore
replied to the thread
Which is which among Cyclone, Hurricane, and Typhoon?
.
Are you saying that tornadoes are spawned, attracted, and strengthened by the warning sirens, in the same way that fog horns thicken the...
Sep 13, 2025
Baluncore
replied to the thread
Automotive
Motor for slider crank
.
How fast must it turn? What force is required? What work will the slider crank do?
Sep 12, 2025
Baluncore
replied to the thread
3-terminal device external modeling
.
For a circuit to be without stored energy, it must be a matrix of resistors. For such a three terminal device, you would be unable to...
Sep 11, 2025
Baluncore
replied to the thread
3-terminal device external modeling
.
The characteristic curve does not show resonances, nor charge or information storage. The S21 parameter is the forward transfer...
Sep 11, 2025
Baluncore
replied to the thread
3-terminal device external modeling
.
Only if it is linear, and you have the four scattering parameters at a number of different frequencies.
Sep 11, 2025
Forums
Back
Top