Thats a very good idea:smile:
However not quite so easy in reality, as it would require some components which could cost considerable amounts of money just to test...
In relation to the pressure, under maximum inlet pressure it would be around 26psi above atmospheric.
Thanks again.
Wow :-)
Thankyou for a very good response...
If i can draw your attention to this post, i have further details of what I am trying to achieve.
If you could have a quick look it would certainly make it easier for you to see what I am explaining, then hopefully you'll be able to give me...
Volume v's Mass airflow...?
Can anybody possible help me to understand how the following situation is affected with respect to the Volume and the Mass Airflow/velocity?
imagine a sealed square box.
On the left hand side is a round inlet.
at the bottom are 4 smaller outlets, in a roow from...
Ok here goes...
1. Attachment 1:
This is the plenum chamber as standard. As you'll be able to see no doubt is the airflow coming in has to turn through a tight elbow, and this elbow is very restictive.
2. Attachment 2:
This is a simple schematic of the plenum, the rectangular box shows where...
Minger,
Thanks very much for the reply.
The runners are unaffected, the plenum is a 'Dry' inlet i.e. Only air, fuel is added in the runners to the head.
The basic design of the plenum is a rectangular box, which encases the four inlet runners. The inlet air into this plenum comes...
Inlet plenum and gas law calculations?
Not sure if this is the best pace to post this question but here goes...
I want to get a custom inlet plenum made for my car, there are many already out there but they cost a fortune, but several people have made there own and the construction is fairly...