Yes, the part is not very large at all. It is roughly 90mm x70mm.
It has all those ribs and holes because it interfaces with several other components. It is actually the lifter of a window regulator. It basically clamps the glass and moves it up and down along a guide.
I wish I could make it...
Hello nvn,
The stiffener was originally much more substantial, but it resulted in a stress concentration right at the corner. This was shown in the first analysis we did, which I have attached. Peak stress was then even higher than now. That was when we decided to make the stiffener more...
Hi,
Thanks a lot for your feedback. It really helps.
The load applied will be static. It corresponds to the load applied by a bolt, which once tightened it won´t be removed anymore.
Based on your feedback I will add an additional rib just like the two taking the stress right now...
Hello,
I have been following this forum for some time now, but this is the first time I participate. I would appreciate if you could give me a hand in understanding the results of a finite element analysis of an automotive component we have designed.
The analysis results indicate that the...