Hats off to you good sir,
I guess I was having a hard time under standing what you guys were talking about but that was a great break down.
After running multiple tests using your guys suggestions I was above to average the voltage at each load to 1.051v which is one heck of a tolerance...
You are correct, one minor detail however;
If I increase the load drive to 1.4v so that RL5 has a drop of 1v then RL will then have a voltage drop of 1.4v...
The drive sense provides feedback which monitors that specific point. RL is actually about 10' from the drive circuit so the sense...
Hey guys,
I am new here so I figured I would post a problem I am having and see what comes out. I am designing a circuit that will force a voltage across a proprietary load that I cannot divulge on, but for this example we will assume it's resistors. So far everything works great but I am still...