About that we assume that the valve will adjust in manually, what we concerned is the flow rate that occurs at the time burst leakage happens. how to calculate the flow rate at the time burst ?
yes, we also assumed like that too. so after disk burst because there is no fluid distribution because valve already closed and stoping distributing fluid from pump then 4000 psi will drop quickly to hydrostatic pressure.
the problem is i want to know how i can calculate the flow rate that...
we have a project to how knowing the flow rate of fluid at the burst leakage due over pressured, probably to make it easier to understand i will attach some pictures of this mechanism.
Picture at above is simply mechanism of pipeline system that installed vertically, with fluid is mud and...
The soure of pressure we assume is only from pump, so pump continuosly produces flow rate 1,4 l/s until whole of pipeline that blocked by relief valve is full filled by water and pump still running, until the pressure reach 4000 psi and makes screw that fixed relief valve broke because of this...
1. we assume that continuity will occurs during pressure drop, so probably Q1 = Q2 then our pump may produced 1.4 Litre/s at 4000 psi also at 450 psi...but does it works in reality ? i don't know if there is pressure drop from 4000 psi to 450 psi in those two conditions will be having same flow...
The pipeline is relatively short with fluid is water / incompressible fluid, wall of pipeline is thick.
pressure is 4000 psi is generated by particular pump at upstream and fluid with that pressure will broke the screw and open the relief valve permanently (relief valve system is only once use...
we assume that;
pipe length : 510 mm
fluid : water
size of the hole : 1256,63 mm2
actually the goal is predict how much pressure drop relating with size of the hole ?
in this case we want to reduce pressure from 4000 PSI in sudden to 450 PSI, does it can ?
so if we cannot use only by one...
We have a project that relating with pipeline system and pressure control, the project is actually having goal to knowing how much pressure drop will occurs in pipe line system that in initial condition the pressure inside the pipeline staying at steady or constant in particular psi and at the...