@jim_hardy :
Well thank you for your answers, it does help. Note that in my case, this not a vehicle so currents will be moderate. But it is a very cool project indeed !
I still haven't found the references for what I want, but some of your words have put me on interesting tracks, so it was...
@Claude :
My application is not about driving LED as you may have seen here above. But anyway, my goal is to track a current reference. That's what I meant by "current control".
In most applications, as you mentionned, the output voltage is to be kept constant. This is achievable through...
@jim_hardy : I took a look at your system. Quite interesting indeed, even though I am probably not experienced enough to grasp its elegance..! Thank you for the link (no i did not have it actually), some schematics could be useful to me.
While reading this pdf, as well as a journal article...
Yes, it is the right flavor. But I had already downloaded it !
It is about "average current mode control" (instead of "peak"), but still, the ultimate goal is to regulate voltage.
Going through an inner current loop is beneficial to the controller design (pole/zero structure of...
Thank you all for your answers. Unfortunately, my application is quite different.
It is a small mobile hybrid power system (fuel cell + battery/supercapacitors).The fuel cell will be interfaced with a DC bus through the converter. The other sources, connected to the bus, are present to...
Hi everyone,
First post on this forum (!)
I am simulating a distributed power generation system for which I need a current regulation on a buck converter (for load sharing between sources)...The model will be turned into a hardware solution so I need a practical solution, preferably...