ASME Boiler and pressure vessel code

AI Thread Summary
The discussion focuses on finding the method for calculating the required cross-sectional area of bolts under internal pressure according to the ASME Boiler and Pressure Vessel Code. A participant suggests checking "Mandatory Appendix 2" for relevant information. The original poster confirms they have reviewed it but did not find the needed details. There is also a query regarding Division 2's approach to this calculation, but the responder admits unfamiliarity with that section. The conversation highlights the difficulty in locating specific calculations within the ASME code.
gabriel
Messages
10
Reaction score
0
Does anybody knwo how calculate the required cross-sectional area of the bolts with internal pressure, according to the ASME code? I mean in which section, appendix, whatever.
I have spent a lot of time trying to find this and I could not. But I can´t believe that an important standard, like this, omits this so common calculation.

thanks in advance.
 
Engineering news on Phys.org
Hi gabriel,
Have you looked through "Mandatory Appendix 2" for what you're looking for? If that doesn't meet your needs, please be more specific.
 
I have just looked it. Thanks a lot.
Do you know if the division 2 has other way for calculating the required cross-sectional area of the bolts?
 
Sorry, but I'm not as familiar with Div 2, so without looking I couldn't say.
 

Thread 'Questions about the Tesla turbine'

Hi all, i have some questions about the tesla turbine: is a tesla turbine more efficient than a steam engine or a stirling engine ? about the discs of the tesla turbine warping because of the high speed rotations; does running the engine on a lower speed solve that or will the discs warp anyway after time ? what is the difference in efficiency between the tesla turbine running at high speed and running it at a lower speed ( as fast as possible but low enough to not warp de discs) and: i...
View full post »

Similar threads

Pressure Vessel Design Question
Replies
3
Views
2K
ASME compliance in Pressure Vessel design
Replies
16
Views
3K
Engineering calculations as a deliverable: standards and references
Replies
2
Views
2K
Radial stress in pressure vessels
Replies
5
Views
24K
Air pressure vessel safety valve size
Replies
1
Views
4K
Hazard levels for pressure vessels with internal bladders
Replies
1
Views
1K
ASME Boiler & Vessel Pressure Code Links
Replies
1
Views
2K
Area Distribution Around Stays in EN 12953 Boiler Standard (10.2.8)
Replies
0
Views
626
What Size Hole Causes a 2 kPa Pressure Drop in a 500L Vessel?
Replies
10
Views
4K
Pressure within two connected vessels
Replies
27
Views
5K

Hot Threads

Recent Insights

Back
Top