Diffraction Understanding a solution

  • Thread starter Thread starter Hebel
  • Start date Start date
  • Tags Tags
    Diffraction
Join the discussion
Registration is free. Ask a follow-up in this thread, or start your own.
6 replies · 1K views
Hebel
Messages
8
Reaction score
0

Homework Statement


(see attached problem)

Homework Equations


(see attached problem)

The Attempt at a Solution


So assuming the area of the hole is circular, halving its diameter, will decrease its area by a factor of 16. Therefore LI will be I/16? However in the solution (see attached solution) it says: 'Halving the diameter of the hole will decrease the power through it by 1/4'. How does one make this conclusion?
 

Attachments

  • Screen Shot 2016-03-09 at 1.19.42 PM.png
    Screen Shot 2016-03-09 at 1.19.42 PM.png
    17.7 KB · Views: 436
  • Screen Shot 2016-03-09 at 1.25.08 PM.png
    Screen Shot 2016-03-09 at 1.25.08 PM.png
    7.3 KB · Views: 431
Physics news on Phys.org
Hebel said:
'Halving the diameter of the hole will decrease the power through it by 1/4'. How does one make this conclusion?
Because ##P=IA##, therefore any change in the scaling of ##A## will result in the same amount of scaling in ##P##.
 
Hebel said:
So assuming the area of the hole is circular, halving its diameter, will decrease its area by a factor of 16. Therefore LI will be I/16? However in the solution (see attached solution) it says: 'Halving the diameter of the hole will decrease the power through it by 1/4'. How does one make this conclusion?
Hebel said:
halving its diameter, will decrease its area by a factor of 16.
perhaps some error is there- Area is proportional to (d/2)^2 !

i think one should remember 'as given' that halving the diameter will decrease the area of hole by a factor of four - but at the same time the diffracted beam increases its width by a factor of 2 - so it leads to a further spread of the same power in four times the area (decrease by a factor of four )so one gets a net 1/16 of the power.
 
Why does twice the width mean 4 times the area?
 
Hebel said:
Why does twice the width mean 4 times the area?
##A_1=\frac{1}{4}\pi D_1^2##. Now if you set ##D_2=2D_1##, what is ##A_2=\frac{1}{4}\pi D_2^2## in terms of ##A_1##?
 
So the new area is 4 times the old one I see, so we are just assuming that the area of the beam incident on the screen will be circular right?
 
Hebel said:
so we are just assuming that the area of the beam incident on the screen will be circular right?
You are supposed to assume that the illumination is of plane wave from the left.