Driving a car onto a semi while both are in motion

  • Thread starter Thread starter Rexmaster
  • Start date Start date
  • Tags Tags
    Car Motion
AI Thread Summary
In the scenario of a car driving onto a moving semi-truck, the outcome largely depends on the driver's actions with the throttle. If the driver maintains acceleration while transitioning onto the ramp, the car could potentially increase its speed relative to the truck, leading to a collision with the truck's cab. Conversely, if the driver lifts off the throttle, the car may coast at a slower speed and could struggle to ascend the ramp. The discussion highlights that the car's speed relative to the ground and the truck will vary based on these throttle adjustments. Ultimately, the dynamics of the situation are complex and depend on the driver's input.
Rexmaster
Messages
1
Reaction score
0
A debate I have long had with my father-in-law. Can someone please set the record straight on what would happen given the following scenario:

Semi truck traveling at 55 MPH with a ramp down on the trailer. A car accelerates to 60 MPH and drives up the ramp and into the back of the trailer.

a) Does the car move across the trailer surface at 60 MPH and thus zooming to the front once in contact.

b) The car continues gaining on the front of the trailer at 5 MPH, thus pulling in slowly.

c) Something else entirely.


Thanks!
Rex
 
Physics news on Phys.org
Welcome to PF, Rexmaster.
Answer "b" is close, but not exact. Mythbusters performed the test a couple of years ago. Exiting the truck was equally painless.
 
 
Last edited by a moderator:
Without any experiments I would say that the car will move at 55+60=115MPH, relative to the ground, and at 5MPH relative to the truck. Is that right?
 
magicacid said:
Without any experiments I would say that the car will move at 55+60=115MPH, relative to the ground, and at 5MPH relative to the truck. Is that right?

That is self-contradictory. If the car is moving at 5mph wrt the truck, how can it be moving at 115mph wrt the ground, if the truck is only moving at 55mph?

Keep analyzing.
 
Much is going to depend on what the driver of the car does with the throttle as the car drives up onto the ramp.

If the driver doesn't lift off as the driving wheels leave the road for the ramp, then the engine will start accelerating the car relative to the truck. This will lead to the car ramming the cab of the truck from behind. If the truck's bed were long enough (several hundred feet) the car could accelerate from 5 mph to 60 mph on the bed of the truck, for a combined speed of 115 mph relative to the ground, before it smashed into the cab at 60 mph.

If the driver lifts off completely, the car will be coasting at 5 mph relative to the ramp. That might not be enough to get it to roll all the way up the ramp.
 
Nugatory said:
Much is going to depend on what the driver of the car does with the throttle as the car drives up onto the ramp.

If the driver doesn't lift off as the driving wheels leave the road for the ramp, then the engine will start accelerating the car relative to the truck. This will lead to the car ramming the cab of the truck from behind.
Actually, what will happen is the engine will stall.

What Mythbusters showed is that the wheels of a car have very little angular momentum. The moment they are on ramp, they immediately slow to match the speed of the surface underneath them. So there's no lurch forward from that.

But you're talking about something different. You're talking about keeping the engine at high enough revs that it should immediately accelerate as-if-from-rest. Except that the wheels are virtually stopped while the engine is revving high. If you're ever been in a car when it comes to a very abrupt halt, most often what happens is the engine just stalls.
 
Nugatory said:
Much is going to depend on what the driver of the car does with the throttle as the car drives up onto the ramp.

If the driver doesn't lift off as the driving wheels leave the road for the ramp, then the engine will start accelerating the car relative to the truck. This will lead to the car ramming the cab of the truck from behind. If the truck's bed were long enough (several hundred feet) the car could accelerate from 5 mph to 60 mph on the bed of the truck, for a combined speed of 115 mph relative to the ground, before it smashed into the cab at 60 mph.

If the driver lifts off completely, the car will be coasting at 5 mph relative to the ramp. That might not be enough to get it to roll all the way up the ramp.

Yes, on a motorcycle for instance, the effect is noticed more. When the front wheel hits the ramp it is like applying the front brake. Once the rear wheel hits the motorcycle starts to accelerate.
 
DaveC426913 said:
Actually, what will happen is the engine will stall.

With a stick-shift, feathering the clutch... It won't stall, that's what the clutch does. On the other hand the throttle setting that maintains a 60 mph cruise on the highway as we approach the ramp isn't going to be enough to accelerate us up the ramp... So I still believe that the original question was incompletely specified and the result will depend on what the driver does with the throttle (and clutch, which I should have mentioned as well).
 
Back
Top