How do I find the decay time constant from an oscilloscope waveform?

9 replies · 3K views · last reply
MissP.25_5
Messages
329
Reaction score
0
What is the decay time constant of the waveform? How to determine it from this oscilloscope?
The waveforms are in the pictures below:
 
Attachments
  • Tektronix oscilloscope screenshot with two square-wave traces: channel 1 in orange at 5.00 mV per division and channel 2 in cyan at 1.00 V per division, both with a 2.50 µs time base and a 100.001 kHz trigger frequency.
    2.5.JPG
    33 KB · Views: 474
  • Oscilloscope screenshot showing two traces: an orange channel 1 trace with noise that steps up sharply around the middle of the screen, and a cyan channel 2 trace that steps up at the same time to a higher plateau. Screen header reads Tek, Trig'd, M Pos 152.0ns, CH1 5.00mV, CH2 1.00V, M 100ns, 3-DEC-13 14:29.
    100.JPG
    24.2 KB · Views: 516
  • Tektronix oscilloscope screenshot with two traces: CH1 in orange at 5.00 mV per division, showing a step rise near the trigger point, and CH2 in cyan at 1.00 V per division, showing a step rise a little later; time base 250 ns per division.
    250.JPG
    19.5 KB · Views: 497
Look at the 100 ns/div. oscillograph (the orhers are useless).

How long would you estimate it takes the bottom trace to get to 63% of its way to the top?

(This would be just an estimate since there may be nonlinearities involved, or two or more time constants. But a pretty good estimate anyway).
 
  • Like
Likes   Reactions: 1 person
rude man said:
Look at the 100 ns/div. oscillograph (the orhers are useless).

How long would you estimate it takes the bottom trace to get to 63% of its way to the top?

(This would be just an estimate since there may be nonlinearities involved, or two or more time constants. But a pretty good estimate anyway).

Thanks for replying but could you explain this method, please?
 
MissP.25_5 said:
Thanks for replying but could you explain this method, please?

Your trace begins at the bottom and ends at the top. How much time along the time axis to reach 63% of the distance from the bottom to the top? Use the 100 ns/div. trace.
 
rude man said:
Your trace begins at the bottom and ends at the top. How much time along the time axis to reach 63% of the distance from the bottom to the top? Use the 100 ns/div. trace.

Should 8~10ns be correct?
 
rude man said:
Yes.
To get a better estimate you should have run 10 ns/division instead of just 100 ns.

Actually, 100ns is the sweep time.
 
rude man said:
Actually, I know.

You should have chosen 10 ns/div. sweep time

Well, I just followed the procedure in the textbook. It says to set the sweep time to 2.5mircrosec, 250nsec and finally 100nsec.
I tried calculated the decay time and taking the best point that I could and I got 9.2ns. Is this ok? By the way, thanks for helping me out.
 
Last edited: